[v4,17/27] drm/i915: Swap planes on each crtc separately, v2.

Submitted by Maarten Lankhorst on June 1, 2015, 10:50 a.m.

Details

Message ID 1433155811-9671-18-git-send-email-maarten.lankhorst@linux.intel.com
State New
Headers show

Not browsing as part of any series.

Commit Message

Maarten Lankhorst June 1, 2015, 10:50 a.m.
Repeated calls to begin_crtc_commit can cause warnings like this:
[  169.127746] BUG: sleeping function called from invalid context at kernel/locking/mutex.c:616
[  169.127835] in_atomic(): 0, irqs_disabled(): 1, pid: 1947, name: kms_flip
[  169.127840] 3 locks held by kms_flip/1947:
[  169.127843]  #0:  (&dev->mode_config.mutex){+.+.+.}, at: [<ffffffff814774bc>] __drm_modeset_lock_all+0x9c/0x130
[  169.127860]  #1:  (crtc_ww_class_acquire){+.+.+.}, at: [<ffffffff814774cd>] __drm_modeset_lock_all+0xad/0x130
[  169.127870]  #2:  (crtc_ww_class_mutex){+.+.+.}, at: [<ffffffff81477178>] drm_modeset_lock+0x38/0x110
[  169.127879] irq event stamp: 665690
[  169.127882] hardirqs last  enabled at (665689): [<ffffffff817ffdb5>] _raw_spin_unlock_irqrestore+0x55/0x70
[  169.127889] hardirqs last disabled at (665690): [<ffffffffc0197a23>] intel_pipe_update_start+0x113/0x5c0 [i915]
[  169.127936] softirqs last  enabled at (665470): [<ffffffff8108a766>] __do_softirq+0x236/0x650
[  169.127942] softirqs last disabled at (665465): [<ffffffff8108ae75>] irq_exit+0xc5/0xd0
[  169.127951] CPU: 1 PID: 1947 Comm: kms_flip Not tainted 4.1.0-rc4-patser+ #4039
[  169.127954] Hardware name: LENOVO 2349AV8/2349AV8, BIOS G1ETA5WW (2.65 ) 04/15/2014
[  169.127957]  ffff8800c49036f0 ffff8800cde5fa28 ffffffff817f6907 0000000080000001
[  169.127964]  0000000000000000 ffff8800cde5fa58 ffffffff810aebed 0000000000000046
[  169.127970]  ffffffff81c5d518 0000000000000268 0000000000000000 ffff8800cde5fa88
[  169.127981] Call Trace:
[  169.127992]  [<ffffffff817f6907>] dump_stack+0x4f/0x7b
[  169.128001]  [<ffffffff810aebed>] ___might_sleep+0x16d/0x270
[  169.128008]  [<ffffffff810aed38>] __might_sleep+0x48/0x90
[  169.128017]  [<ffffffff817fc359>] mutex_lock_nested+0x29/0x410
[  169.128073]  [<ffffffffc01635f0>] ? vgpu_write64+0x220/0x220 [i915]
[  169.128138]  [<ffffffffc017fddf>] ? ironlake_update_primary_plane+0x2ff/0x410 [i915]
[  169.128198]  [<ffffffffc0190e75>] intel_frontbuffer_flush+0x25/0x70 [i915]
[  169.128253]  [<ffffffffc01831ac>] intel_finish_crtc_commit+0x4c/0x180 [i915]
[  169.128279]  [<ffffffffc00784ac>] drm_atomic_helper_commit_planes+0x12c/0x240 [drm_kms_helper]
[  169.128338]  [<ffffffffc0184264>] __intel_set_mode+0x684/0x830 [i915]
[  169.128378]  [<ffffffffc018a84a>] intel_crtc_set_config+0x49a/0x620 [i915]
[  169.128385]  [<ffffffff817fdd39>] ? mutex_unlock+0x9/0x10
[  169.128391]  [<ffffffff81467b69>] drm_mode_set_config_internal+0x69/0x120
[  169.128398]  [<ffffffff8119b547>] ? might_fault+0x57/0xb0
[  169.128403]  [<ffffffff8146bf93>] drm_mode_setcrtc+0x253/0x620
[  169.128409]  [<ffffffff8145c600>] drm_ioctl+0x1a0/0x6a0
[  169.128415]  [<ffffffff810b3b41>] ? get_parent_ip+0x11/0x50
[  169.128424]  [<ffffffff811e9ab8>] do_vfs_ioctl+0x2f8/0x530
[  169.128429]  [<ffffffff810d0fcd>] ? trace_hardirqs_on+0xd/0x10
[  169.128435]  [<ffffffff812e7676>] ? selinux_file_ioctl+0x56/0x100
[  169.128439]  [<ffffffff811e9d71>] SyS_ioctl+0x81/0xa0
[  169.128445]  [<ffffffff81800697>] system_call_fastpath+0x12/0x6f

Solve it by using the newly introduced drm_atomic_helper_commit_planes_on_crtc.

The problem here was that the drm_atomic_helper_commit_planes() helper
we were using was basically designed to do

    begin_crtc_commit(crtc #1)
    begin_crtc_commit(crtc #2)
    ...
    commit all planes
    finish_crtc_commit(crtc #1)
    finish_crtc_commit(crtc #2)

The problem here is that since our hardware relies on vblank evasion,
our CRTC 'begin' function waits until we're out of the danger zone in
which register writes might wind up straddling the vblank, then disables
interrupts; our 'finish' function re-enables interrupts after the
registers have been written.  The expectation is that the operations between
'begin' and 'end' must be performed without sleeping (since interrupts
are disabled) and should happen as quickly as possible.  By clumping all
of the 'begin' calls together, we introducing a couple problems:
 * Subsequent 'begin' invocations might sleep (which is illegal)
 * The first 'begin' ensured that we were far enough from the vblank that
   we could write our registers safely and ensure they all fell within
   the same frame.  Adding extra delay waiting for subsequent CRTC's
   wasn't accounted for and could put us back into the 'danger zone' for
   CRTC #1.

This commit solves the problem by using a new helper that allows an
order of operations like:

   for each crtc {
        begin_crtc_commit(crtc)  // sleep (maybe), then disable interrupts
        commit planes for this specific CRTC
        end_crtc_commit(crtc)    // reenable interrupts
   }

so that sleeps will only be performed while interrupts are enabled and
we can be sure that registers for a CRTC will be written immediately
once we know we're in the safe zone.

The crtc->config->base.crtc update may seem unrelated, but the helper
will use it to obtain the crtc for the state. Without the update it
will dereference NULL and crash.

Changes since v1:
- Use Matt Roper's commit message.

Signed-off-by: Maarten Lankhorst <maarten.lankhorst@linux.intel.com>
Reviewed-by: Matt Roper <matthew.d.roper@intel.com>
---
 drivers/gpu/drm/i915/intel_atomic.c  | 13 +++----------
 drivers/gpu/drm/i915/intel_display.c |  5 +++--
 2 files changed, 6 insertions(+), 12 deletions(-)

Patch hide | download patch | download mbox

diff --git a/drivers/gpu/drm/i915/intel_atomic.c b/drivers/gpu/drm/i915/intel_atomic.c
index e93aade0f2dc..83078763ba14 100644
--- a/drivers/gpu/drm/i915/intel_atomic.c
+++ b/drivers/gpu/drm/i915/intel_atomic.c
@@ -151,18 +151,11 @@  int intel_atomic_commit(struct drm_device *dev,
 
 		if (INTEL_INFO(dev)->gen >= 9)
 			skl_detach_scalers(to_intel_crtc(crtc));
+
+		drm_atomic_helper_commit_planes_on_crtc(crtc_state);
 	}
 
-	/*
-	 * FIXME:  The proper sequence here will eventually be:
-	 *
-	 * drm_atomic_helper_commit_modeset_disables(dev, state);
-	 * drm_atomic_helper_commit_planes(dev, state);
-	 * drm_atomic_helper_commit_modeset_enables(dev, state);
-	 *
-	 * once we have full atomic modeset.
-	 */
-	drm_atomic_helper_commit_planes(dev, state);
+	/* FIXME: This function should eventually call __intel_set_mode when needed */
 
 	drm_atomic_helper_wait_for_vblanks(dev, state);
 	drm_atomic_helper_cleanup_planes(dev, state);
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 3538a1059db0..b1457a53b2b5 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -12646,10 +12646,10 @@  static int __intel_set_mode(struct drm_atomic_state *state)
 
 	modeset_update_crtc_power_domains(state);
 
-	drm_atomic_helper_commit_planes(dev, state);
-
 	/* Now enable the clocks, plane, pipe, and connectors that we set up. */
 	for_each_crtc_in_state(state, crtc, crtc_state, i) {
+		drm_atomic_helper_commit_planes_on_crtc(crtc_state);
+
 		if (!needs_modeset(crtc->state) || !crtc->state->active)
 			continue;
 
@@ -15010,6 +15010,7 @@  static void intel_modeset_readout_hw_state(struct drm_device *dev)
 		struct intel_plane_state *plane_state;
 
 		memset(crtc->config, 0, sizeof(*crtc->config));
+		crtc->config->base.crtc = &crtc->base;
 
 		crtc->config->quirks |= PIPE_CONFIG_QUIRK_INHERITED_MODE;